We no longer support this version of Internet Explorer. Please update your browser for a better experience of All4.com. For more information visit our FAQs

Section navigation

Beef Burgers Recipe

Heston: "The secret to a really tender burger is all in the way the meat is ground or more specifically, how it is treated after grinding. By ensuring the individual strands of meat face in the same direction as outlined below, you will guarantee succulent burgers every time. How you garnish your burger is up to you but for me, it has to be with melted cheese, mustard and dill pickles.

If you cannot get brioche buns, go for really soft rolls, otherwise the filling will squish out. If you can’t get sweet onions, soak the onions in water for 10 minutes or quickly blanch them in boiling water for 30 seconds."

Makes 10


For the burgers

  • 1.8kg sirloin, cut into 3x3cm cubes
  • 13g salt

For the sauce

  • 90g tomato ketchup
  • 145g mayonnaise
  • 15g French's mustard

To serve

  • 10 sliced burger buns, toasted
  • 10 slices gruyère cheese
  • 2 baby gem lettuces, broken into leaves
  • 2 vine-ripened tomatoes, sliced
  • ½ sweet onion, peeled and finely sliced
  • 2 dill pickles, sliced lengthways


1. Place 600g of the cubed sirloin in a bowl and sprinkle with the salt. Mix together, cover with clingfilm then place in the fridge for 4 hours. The salt will penetrate the meat during this time and begin to draw out some of the moisture.

2. Using a meat grinder fitted with a 3mm plate, grind the unsalted sirloin then refrigerate this meat until very cold. Combine the cold ground meat with the cold, salted sirloin cubes and mix well.

3. Before you begin the final grinding, place two layers of clingfilm across a chopping board or baking sheet and position it under the mouth of the grinder. Using a coarser, 8mm grinding plate, pass the meat mixture through the grinder. This will retain some larger pieces of the sirloin.

4. As the meat comes out of the grinder, have a second person use their hands to lay out the strands of meat on the clingfilm. Try to keep the grain of the individual strands running lengthwise in the same direction without getting tangled together. To do this, start laying the meat down at the edge of the sheet furthest from the grinder and work towards the closest edge.

5. Wrap the meat up tightly in the clingfilm, twisting the ends tightly to form a log. Prick a few holes in the clingfilm with a pin to release any air pockets trapped inside, then continue to twist the ends to tighten until the log is about 12cm in diameter.

6. Wrap the log in another layer of clingfilm to keep it from coming apart, and refrigerate for at least 2 hours, or until needed.

7. When ready to cook, place the still-wrapped log on a cutting board and use a very sharp knife to cut slices that are approximately 2cm in thickness. (The clingfilm helps to keep the meat from falling apart.) Place the finished burgers on a baking tray and refrigerate until needed. If you have more burgers than you need, they can be individually wrapped in clingfilm at this point and frozen until needed.

8. To cook the burgers, rub each one with a little oil and place them on the barbecue or a really hot frying pan, and flip them every 15–20 seconds. Cook to your liking or for medium rare, take the burger to 45ºC in the centre. Immediately after the last flip, place a slice of cheese on top of each burger and allow to melt for the final 15 seconds.

9. To make the sauce, combine the ketchup, mayonnaise and mustard in a bowl and mix thoroughly.

10. To serve, place the bottom half of a bun on a plate and put a burger with melted cheese on top. Place a couple of slices of tomato and onions followed by a couple of leaves of lettuce and a couple of slices of pickles. Finish with a spoon full of sauce. Place the top half of the bun on top and serve.

Recipe from Heston Blumenthal at Home, Published by Bloomsbury