1. Step One
1. Step One (Image 1 of 4)
Dig holes for each post according to the concrete pack instructions (usually at least 450mm deep). Normally, the hole is half filled with water and the powder mix is poured on top.
Expert DIY Advice From George Clarke
How To Lay Laminate Flooring
How To Bleed A Radiator
How To Fit A Bathroom Sink
How To Fit Wall Tiles
How To Tile A Floor
How To Grout Tiles
How To Seal Around A Basin
How To Erect A Fence
How To Prepare & Paint Interior Woodwork
How To Level A Floor
How To Screed A Floor
How To Unblock A Toilet
How To Build A Brick Wall
How To Sand A Floor
How To Strip Paint
How To Remove Old Floor Tiles
How To Remove Old Floorboards
How To Fix Squeaky Floorboards
How To Fit Underfloor Heating
How To Fit A Radiator
How To Hang A Door
How To Wire A Plug Socket
Need Expert Help?
Post your job on MyBuilder now and find a trusted tradesman in your area.
Use our service to find a reputable local builder, based on the ratings of their real-life clients
Our presenter could be popping round to your house for a consultation and a cuppa

Your Comments
Post your comment
Please note: In order to post a comment you need to be registered and logged in to Channel 4:
Sign In Here or Register Here
Comments closed
Comments are closed at the present time
Comments
Thank you for your comment!
Your message will be reviewed and the best ones will be published below.
If you intended to make an official comment to Channel 4 please contact us.
Comments