3. Step Three
3. Step Three (Image 3 of 9)
If you find loose boards that have been lifted to install central heating or electrics, nail battens along the edges of the adjacent joists so that the board will sit flush with the rest of the floor. Drill small clearance holes in each corner of the board to stop the wood splitting and screw into place. Make sure the screws are at least 2mm below the surface.
Expert DIY Advice From George Clarke
How To Level A Floor
How To Screed A Floor
How To Unblock A Toilet
How To Build A Brick Wall
How To Sand A Floor
How To Strip Paint
How To Remove Old Floor Tiles
How To Remove Old Floorboards
How To Fix Squeaky Floorboards
How To Fit Underfloor Heating
How To Fit A Radiator
How To Hang A Door
How To Wire A Plug Socket
How To Lay Laminate Flooring
How To Bleed A Radiator
How To Fit A Bathroom Sink
How To Fit Wall Tiles
How To Grout Tiles
How To Seal Around A Basin
How To Set Fence Posts In Concrete
How To Erect A Fence
How To Prepare & Paint Interior Woodwork
How To Tile A Floor
Use our service to find a reputable local builder, based on the ratings of their real-life clients
Our presenter could be popping round to your house for a consultation and a cuppa
Tips on refreshing your home for Christmas, plus expert advice on common DIY jobs
Your Comments
Post your comment
Please note: In order to post a comment you need to be registered and logged in to Channel 4:
Sign In Here or Register Here
Comments closed
Comments are closed at the present time
Comments
Thank you for your comment!
Your message will be reviewed and the best ones will be published below.
If you intended to make an official comment to Channel 4 please contact us.