Now start the second row, using the off-cut of the board used at the end of the first row. Always stagger the end joints of adjacent rows by at least 30cm. Use the fitting tool to push the ends of the boards together. Work your way across the room, pushing the rows against the plastic spacers. Tighten each joint by tapping the edge block against the grooved side of each board.
Mark the position of any pipes on the board to be laid. Drill a hole about 5mm larger in diameter than the pipe. Make two angled saw cuts from the edge of the board to the sides of the drilled hole. Fit the board and carefully glue the small off-cut wedge behind the pipe.
If the last row of boards needs to be cut, measure the gap between the boards and the wall, deduct 10mm and saw the boards lengthways to fit. Glue the joints and force into place with the fitting tool. Mark and cut out the ends of any boards that fit around corners or obstacles.
Refit your skirting boards. If you don’t want to remove and refit your skirting boards, fit the floor with them where they are and add a quadrant moulding around the edge to cover the gap between the boards and the skirting.
Use our service to find a reputable local builder, based on the ratings of their real-life clients
Our presenter could be popping round to your house for a consultation and a cuppa
Tips on refreshing your home for Christmas, plus expert advice on common DIY jobs
Your Comments
Post your comment
Please note: In order to post a comment you need to be registered and logged in to Channel 4:
Sign In Here or Register Here
Comments closed
Comments are closed at the present time
Comments
Thank you for your comment!
Your message will be reviewed and the best ones will be published below.
If you intended to make an official comment to Channel 4 please contact us.